| For Sale |
 | |  | |  |
For Sale Page
This is where you might find some stuff I'm
unloading which is not that often but
sometimes good to just unload some unused
bits and pieces.
This is where you might find some stuff I'm
unloading which is not that often but
sometimes good to just unload some unused
bits and pieces.
| Parts Listing as of 06/11/2008 Pictures Available! Fluidyne 65-66 Mustang Radiator Excellent condition, never used with an iron motor (Read as NO RUST), very clean inside and out, a few bugs included at no extra charge. $300, Includes stainless mesh for front. This is a 3 core thick aluminum racing radiator. It is the best radiator that will fit in an early mustang without cutting up the car. I think it has mounts for the shroud but never ran one so don't know. You will not often see these used in any condition. Replacing with larger radiator. Fiberglass mustang doors, and front fenders 65-66 Mustang If you have the skills you can remove a ton of weight. $200 for it all Ford CompCams SBF Solid Lifters Still wrapped, need to do that solid lifter K Code motor, here it is, NIB $60 CompCams Stainless Steel 1.6 Rockers for SBF Ford NO Locks, made in USA not imports $80 Edelbrock Victor JR for 289-302 Used a little then pulled moved up to his papa the Victor Sr. $125 Cobra finned Aluminum valve covers (from Tony Branda #VC24's) 2 SETS Almost new, excellent shape $80 a set and will fit roller rockers. 65-66 Mustang 5 Speed conversion, Bell housing to drive shaft! Includes McLeod Scatter Shield for TKO, McLeod aluminum flywheel, pressure plate, dual friction clutch (all used, in car and working until blown engine) , TKO 500 transmission, JMC TKO hydraulic clutch system (except master cyl to pedal), McLeod gear reduction starter, Rear transmission crossmember for TKO, 1350 U-Joint trans slip yoke (might be billet, can't remember will look), Coleman Aluminum Racing Drive shaft for 1350's U-joints both ends, Steeda Triax shifter with vintage Hurst short handle and white 5 speed hurst ball. Also may have the stock TKO shifter. This is still in the car pending removal $2000 Man that is a lot of stuff for the price... Canton deep sump road race pan, and windage tray for 302. Internal scraper flattened to support stroker motor. All for $175 (15-610 pan, 15-611 pickup, 20-931 Windage Tray) Chevrolet ZL-1 Big Block Chevy Camshaft Unused, this is the mechanical cam from the Chevy power book and the original grind used in the ZL-1 motors. New in wrapper from Skogings Dicky. $100 BF Goodrich R1's Racing tires 335-40-R17 New but ~7 years old These are a PAIR of the older style tires, mounted but never driven. $100 I/O Port Racing Roll Bar Camera Mount for Video Camera Isolated Type Hey, I made my own why would I need this anymore $50 Big Block Chevy Aluminum Mock Engine with all mounting points This is an all aluminum tube and plate build mock engine. Has all mounting points for a Standard Deck Big Block Chevy $75 Rev Kit for Big Block Chevy Roller (Comp cams I think) Unused $50 I WILL NOT SHIP, LOCAL PICK UP ONLY Local to the San Fernando Valley in Southern California. Shoot a message to- theripper[at] pacbell.net (Replace the [at] with the @ if that's not obvious) CASH only, but I always will trade for hard labor... All parts subject to prior sale and all are sold in AS IS Condition |
